Zinc selenide

Zinc selenide
Image:Zinc selenide.jpg
General
Other names
Molecular formula	ZnSe
Molar mass	144.35 g/mol
Appearance	light yellow solid
CAS number	[1315-09-9] [1]
Properties
Density and phase	5.27 g/cm³, solid
Solubility in water	Insoluble
Melting point	1525 °C
Boiling point	? °C
Thermodynamic data
Standard enthalpy of formation Δ_fH°_solid	−177.6 kJ/mol
Standard molar entropy S°_solid	???? J.K⁻¹.mol⁻¹
Hazards
EU classification	Dangerous for the environment (N)
R-phrases	R20 R22 R36 R38 R23/R25,R33
S-phrases	?????
NFPA ???
Supplementary data page
Structure and properties	n, ε_r, etc.
Thermodynamic data	Phase behaviour Solid, liquid, gas
Spectral data	UV, IR, NMR, MS
Regulatory data	Flash point, RTECS number, etc.
Related compounds
Other anions	Zinc sulfide Zinc oxide Zinc telluride
Other cations	Cadmium selenide Mercury selenide
Except where noted otherwise, data are given for materials in their standard state (at 25 °C, 100 kPa) Infobox disclaimer and references

Zinc selenide (Zn Se), is a light yellow binary solid compound. It is an intrinsic semiconductor with a band gap of about 2.7 eV at 25 °C. It has a standard enthalpy of formation of 177.6 kJ/mol at 25 °C. It adopts a Zincblende lattice structure with lattice constant a=566.8 picometers.

ZnSe rarely occurs in nature. It is found in the mineral stilleite named after Hans Stille.

[edit] Applications

ZnSe is used to form II-VI light-emitting diodes and diode lasers. It emits blue light. It is susceptible to n-type doping with, for instance, halogen elements. P-type doping is more difficult, but can be achieved by introducing nitrogen.
ZnSe doped with chromium (ZnSe:Cr) has been used as an infrared laser gain medium emitting at about 2.5 µm.
It is used as an infrared optical material with a remarkably wide transmission wavelength range (0.6 μm to 20 μm). The refractive index is about 2.67 at 550 nm (green), and about 2.40 at 10.6 µm (LWIR). ZnSe is sometimes called by the names Irtran-4 or Raytran as an infrared material (Raytran is a trade mark of the Raytheon company). Zinc selenide slowly reacts with atmospheric moisture, which leads to degradation of the optical surfaces when the lenses are exposed to humidity. Coated optics are available, with moisture sensitivity significantly diminished.
ZnSe doped with tellurium (ZnSe(Te)) is a scintillator with emission peak at 640 nm, suitable for matching with photodiodes. It is used in x-ray and gamma ray detectors. ZnSe scintillators are significantly different from the ZnS ones.

ZnSe reacts with acids to form toxic hydrogen selenide gas.

It is grown by chemical vapour deposition techniques including MOVPE.

Cr²⁺ excitation levels in ZnSe and ZnS, G. Grebe, G. Roussos and H.-J. Schulz, J. Phys. C: Solid State Phys. vol. 9 pp. 4511-4516 (1976) DOI:10.1088/0022-3719/9/24/020